Lanner LEC-2220 Manual de usuario descargar pdf (Pagina 22)

Hardware Setup

Chapter 4

Embedded and Industrial Computing

Installing the Hard Disk

The system can accommodate one Serial-ATA disk. Follow

these steps to install a hard disk into the system:

Take out the hard disk tray and fix the hard disk on 1.

the tray with 4 mounting screws as illustrated in the

following picture.

Plug the Serial-ATA cable to the hard disk.2.

Place the hard disk back to the system’s chassis and fix 3.

it with the mounting screws.

Connect the Serial-ATA power and data disk cables to 4.

the Serial-ATA power and disk connectors on the main

board respectively.

PCI/PCIe Riser Card Installation

The system can accommodate one PCI or PCIe expansion

(two PCI or PCIe expansion on model P2) module. In order

the install the PCI or PCIe expansion module, a low-profile

riser card has to be installed first. Follow these steps to

install the riser card:

Fix the riser card on the bracket with 3 screws.1.

Install the riser card on the system by connecting the 2.

connectors with the system’s PCIPCIE connector.

Fix the riser card on the board.3.

Connect the PCIe expansion card to the riser.4.

Fix the card holder to the system5.

On 2220P with one PCIe slot

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 31 32

Sin comentarios

Lanner LEC-2220 Manual de usuario Pagina 22